**the stopping power**. The linear stopping power of material is defined as the

**ratio**of the

**differential energy loss**for the particle within the material to the corresponding

**differential path length**:

,where T is the kinetic energy of the charged particle, n_{ion} is the number of electron-ion pairs formed per unit path length, and I denotes the average energy needed to ionize an atom in the medium. For charged particles, **S increases as the particle velocity decreases**. The classical expression that describes the specific energy loss is known as the Bethe formula. The non-relativistic formula was found by Hans Bethe in 1930. The relativistic version (see below) was found also by Hans Bethe in 1932.

In this expression, m is the rest mass of the electron, β equals to v/c, what expresses the particle’s velocity relative to the speed of light, γ is the Lorentz factor of the particle, Q equals to its charge, Z is the atomic number of the medium and n is the atoms density in the volume. For nonrelativistic particles (heavy charged particles are mostly nonrelativistic), dT/dx is **dependent on 1/v ^{2}**. This is can be explained by the greater time the charged particle spends in the negative field of the electron, when the velocity is low.

**The stopping power** of most materials is very high for heavy charged particles and these particles have very short ranges. For example, the range of a 5 MeV alpha particle is approximately only 0,002 cm in aluminium alloy. Most alpha particles can be stopped by an ordinary sheet of paper or living tissue. Therefore the shielding of alpha particles does not pose a difficult problem, but on the other hand alpha radioactive nuclides can lead to serious health hazards when they are ingested or inhaled (internal contamination).

**Specifics of Fission Fragments**

The fission fragments three two key features (somewhat different from alpha particles or protons), which influence their energy loss during its travel through matter.

**High initial energy.**Results in a large effective charge.**Large effective charge.**The fission fragments start out with lack of many electrons, therefore their specific loss is greater than alpha’s specific loss, for example.-
**Immediate electron pickup.**Results in changes of (-dE/dx) during the travel.

These features results in the continuous decrease in the effective charge carried by the fission fragment as the fragment comes to rest and continuous decrease in -dE/dx. The resulting decrease in -dE/dx (from the electron pickup) is larger than the increase that accompanies a reduction in velocity. The range of typical fission fragment can be approximately half that of a 5 MeV alpha particle.

We hope, this article, **Stopping Power – Bethe Formula**, helps you. If so, **give us a like** in the sidebar. Main purpose of this website is to help the public to learn some interesting and important information about radiation and dosimeters.